Calibrating the Automatic N380 Shifting System:

1. Turn system power on

2. Pedal the bicycle lightly through the entire calibration procedure - have the rear wheel off the ground while pedaling, you can lean the bike over on the kickstand with the help of a friend.

3. Press and hold the "mode" button (the silver/chrome button on the shifter) until the rear hub begins shifting (5-7 seconds typically), then release the button.

4. Continue pedaling lightly while the system shifts from "low" to "high" ratio multiple times and completes the calibration.

You should hear the hub interface (black part by the wheel) make some noise during this process. Once complete, the shifter will stop flashing. If unsuccessful, unplug the interface down by the wheel, and reconnect - then repeat the procedure.

Here's a video on the procedure:

Here is a link to download  the complete manual for your reference: