1. Customer Support
  2. Solution home
  3. Bicycle Operation, DIY Service, & Troubleshooting
  4. Bicycle Operation - Shifting, Pedal Assist, etc.

Enviolo/Nuvinci Cable Shifter and Interface Instructions

Thomas Weber
Modified on: Mon, 7 Aug, 2023 at 3:27 PM

Installing cables in handlebar shifter

https://support.enviolo.com/hc/en-us/articles/11954208675858-How-to-replace-shifter-cables-#video-instructions


Resetting overdrive:

https://support.enviolo.com/hc/en-us/articles/11954329619730-How-to-reset-a-135mm-solid-axle-hub-to-full-overdrive-using-the-manual-hub-interface



Interface installation on hub:

https://support.enviolo.com/hc/en-us/articles/11954255480338-How-to-assemble-manual-hub-interface-on-a-135mm-solid-axle-hub



Cable hardware installation at hub end:

https://support.enviolo.com/hc/en-us/articles/11954225839634-How-to-set-the-cable-length-for-the-manual-hub-interface-with-the-enviolo-cable-tool-

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.

Related Articles

  • How does the Harmony Automatic Shifter work?
  • How do I use the automatic transmission functionality?
  • How to use the NuVinci / Enviolo Harmony Automatic Shifter
  • How to use Pedal Assistance and Throttle Modes
  • How often should I charge my electric bike battery?
  • How do I shift the gears on my Harmony?
  • Should I run the battery down to empty before charging?
  • How to Improve Battery Range
  • How do I use my NuVinci standard (mechanical) shifter?
  • How do I store the battery long-term?
  • How to properly store your EVELO Electric Bicycle
  • PAS Explanation for Delta / Delta X (Summer 2018)
  • My automatic shifting system doesn’t work. Why?
  • I can’t shift under power.
  • Should I just leave the Harmony in high gear?
  • It feels hard to shift. What do I do?
  • My bike feels hard to pedal or feels slow.
  • The bike doesn’t go as far as I expected. Why?
  • When I ride up a hill, the battery range seems to drop quickly.
  • Adjusting the Shimano Nexus 3 Speed Internally Geared Hub
  • Using your Enviolo Automatiq System and CLiQ Pure Controller (formerly CO Controller)
  • Enviolo Automatiq Calibration
  • Automatiq Pairing - CO Controller
  • QR Codes For Automatiq - All EVELO Models
  • Enviolo Automatiq Firmware Update - 110623
  • Post Break In Maintenance
  • Tightening Outer Spline Nut on N380CVT
  • Enviolo Automatiq Failed Calibration
Article views count