Pairing Enviolo App to Automatiq Interface

Thomas Weber

Modified on: Fri, 20 May, 2022 at 10:52 AM

Pairing your phone to the Automatiq system should only take a few moments.

Written instructions are below and you can see a video of the process here:

https://youtu.be/Dn4_hNGowno

The sequence of these steps is incredibly important. Follow them exactly for the easiest pairing.

Download the Enviolo Automatiq App onto your phone. Keep the app closed for now.

Power down the bicycle and leave it off for 3-5 minutes (until the CO controller LED stops blinking)

Power on the display but leave the CO controller asleep.

Push the button on the hub interface until it blinks blue. It should be pushed and held for 3 seconds.

Then turn on Bluetooth on your phone.

Open the Automatiq app.

The app will find and display an interface.

Click on it to pair. You will see a message indicating synchronizing. Once paired it will jump to the main screen of the app unless it's the first time you are using the app or if there is a firmware update.

Enter your personal info into the app and save it before moving on. You will get a notice saying it's saved. Then click the X in the top right corner to exit - make sure the bicycle's display doesn't power down due to inactivity after 3 minutes or else you have to start over. The display will give you a countdown - push any button to return to the main screen on the bicycle display.

If there is a recent update, the app will automatically tell you and ask you to update before anything else can be done. You should always do an update if available.

After an update you have to calibrate, which will require you to ride the bicycle in pas 0 while it goes through the process.

Now you can use the app as desired, whether that is to update the settings for automatic shifting or to use the dashboard on the app to control the gears while riding.

Factory Settings for Aurora Limited

active profile - comfort

units - imperial

operation mode - automatic

manual gear - 9

desired cadence - 55

cadence increments - 5 rpm

gear ratio at start - .8

You can also link to the Aurora Limited settings here:

Factory Settings for Galaxy 500

active profile - comfort

units - imperial

operation mode - automatic

manual gear - 9

desired cadence - 60

cadence increments - 5 rpm

gear ratio at start - .8

You can also link to the Galaxy 500 settings here:

Related Articles